I started by adding the lower bar to the cage door. This bar will act as a nerf bar also. I first set it up coming off the frame at a 90 degree angle.

Here I added a mock up of the side top rail. This was a good idea because it showed that the position of the lower door bar was too low. The upper bar wasn't high enough. So we cut it back off and rotated it up at an angle. This also narrowed the bottom a little more which helped to keep the rig from looking so square. I used lumber to space the seat up to get it close to where it will need to be. I'm hoping once I get the atlas in, I can lower the tranny and t-case so the seat doesn't have to sit so high.

Here is the required poser shot...

Well, I wanted to put the hood on and set the seat up to where it looked correct so I could get an idea where to have the roof bars.

next page